Seattle Scissor Lift Certification

Seattle Scissor Lift Certification - Scissor lift platforms are utilized at work sites to allow tradespeople - like masons, iron workers and welders - to reach their work. Using a scissor lift platform is usually secondary to their trade. Hence, it is vital that all operators of these platforms be trained correctly and licensed. Lift manufacturers, regulators and industry all work together to be able to ensure that operators are trained in the safe use of work platforms.

Scissor lift work platforms are also referred to as manlifts or AWPs. These work machinery are rather easy to operate and provide a steady work surroundings, nevertheless they do have risks as they lift people to heights. The following are various important safety issues common to AWPs:

There is a minimum safe approach distance (likewise known as MSAD) for all platforms in order to protect from accidental discharge of power due to nearness to power lines and wires. Voltage could arc across the air and cause injury to workers on a work platform if MSAD is not observed.

Caution should be taken when lowering a work platform to ensure steadiness. The boom must be retracted, when you move the load toward the turntable. This will help maintain steadiness during lowering of the platform.

Regulations do not mandate individuals working on a scissor lift to tie off. Nonetheless, workers might be needed to tie off if required by employer guidelines, job-specific risk assessments or local regulations. The anchorage provided by the manufacturer is the only safe anchorage to which harness and lanyard combinations must be connected.

Observe the maximum slope rating and do not go beyond it. A grade can be measured by laying a board or straight edge on the slope. A carpenter's level could then be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the length of the straight edge, then multiplying by 100, the per cent slope can be determined.

A standard walk-around check should be done to determine if the unit is mechanically safe. A site assessment determines if the work place is safe. This is essential especially on changing construction locations because of the risk of obstacles, contact with power lines and unimproved surfaces. A function test needs to be carried out. If the unit is used safely and correctly and proper shutdown measures are followed, the possibilities of accidents are really lessened.

Click to Download the pdf